• Model 125 Stereo Amplifier
      • Model 125 Stereo Amplifier
      • Model 125 Stereo Amplifier

      Jeff Rowland

      Jeff Rowland Model 125 Stereo Amplifier

      (0)

      $4,100.00

      In stock (0) - 10 - 20 days Available in store: Check availability

      The Model 125 stereo bridgeable power amplifier delivers dynamic realism and refinement from its solid aircraft-grade aluminum chassis, a perfect match for the sleek profile of its companion Capri S2 preamplifier.

      Product description

      Jeff Rowland Model 125 Stereo Amplifier

      From a single M125 in stereo mode powering an intimate analog system, up to several bridged units driving a multi-speaker setup, down to a bridged pair controlling demanding 4-Ohm monitors, the energy-efficient Model 125 power amplifier delivers consistent resolution and authority with Rowland finesse.

      Machined Aluminum Chassis

      Precision-machined from a solid block of aircraft grade 6061-T6 aluminum, provides exceptional thermal heat transfer/dissipation, RFI/EMI shielding, and resonance control.

      Balanced Topology

      Inherent cancellation effects of balanced topology implemented throughout all power and input/output circuits ensures greatly reduced distortion and noise under dynamic signal conditions.

      High-Precision Surface Mount Components

      Extensive use of Lead (Pb)-free, low temperature coefficient, active and passive surface-mount components results in significantly smaller loop areas, reduced circuit capacitance and inductance, and introduces less noise than conventional leaded components.

      Teflon Coated Wires

      All signal carrying input and output wires are teflon coated, also for low dielectric energy storage, further ensuring that each audio note reproduced naturally decays into the deeper silence of the music.

      Transformer-Coupling and Isolation

      Transformer coupled input circuitry provides universal component compatibility and virtually eliminate ground loop noise and RFI/EMI. Transformer coupling ensures identical amplifier overall gain when using unbalanced input adapters.

      High-Efficiency Switch-Mode Power Supply

      Highly efficient, compact, light weight, switch-mode power supply provides optimum voltage regulation for all circuits and operating conditions, and allows for quiet operation over a wide range of AC mains power sources.

      Parallel Binding Posts

      CE approved speaker output terminals require no tools for secure, low resistance connections, and allow for easy bi-wiring applications.

      Flexible 15 Amp AC Power

      15 Amp AC power inlet accepts a wide variety of after-market high-performance power cables.

      Front Panel Standby Button

      Illuminated front panel push-button switches the amplifier into standby mode (< 1 watt consumption).

      Rear Panel Remote Jack

      12V 3.5mm jack on rear panel permits amplifier power on/standby switching in remote and home theater applications.

      Jeff Rowland Model 125 Stereo Amplifier User's Manual

      Specifications

      Output Power (Stereo)

      125 watts @ 8 ohms / 250 watts @ 4 ohms

      Output Power (Bridge-tied Load)

      500 watts @ 8 ohms BTL

      Frequency Response

      5 Hz – 130 kHz, -3dB

      Input Impedance

      40k ohms

      THD + Noise

      < 0.008% @ 1kHz

      Damping Factor

      > 500,  @ 1kHz

      Overall Gain

      26

      Amplifier Weight

      7.8 lbs. 

      Overall Amplifier Dimensions

      2.7” ( H )  x 13.7” ( W ) x 7.5” ( D )

      Available in store

      Close
      Login

      Forgot your password?

      • All your orders and returns in one place
      • The ordering process is even faster
      • Your shopping cart stored, always and everywhere

      compare0