The Monitor Audio Installation Amplifiers are configurable to 1, 2, 3, 4, 5, 6, or 12 channels. The IA 150-8C enables up to eight ( four stereo pairs ) channels of 150 watts of power at four ohms. It’ll fit 1U rack height and, as a member of the Monitor Audio ‘Connect’ division, it employs our Connect IP interface, a web application which can be accessed by any device connected to the internet with a web browser on the same network.

The IP control is via the RJ-45 input, controlling power On / Off, volume, muting, and input source selections. Perfectly prepared for any project, the IA 150-8C’s industry standard removable block connectors accept up to 12-gauge ( 3.5 mm ) cable. Together with the rest of the Installation Amplifier range, the IA 150-8C provides the brain as well as the brawn for the mightiest of projects.

Monitor Audio IA150 Installation Amplifier User's Manual

Specifications

'Connect' IP Control: Yes

Channel Number: 8 ( 4 Stereo Pairs )

Power ( watt / channel )at 4 ohms: 150 watt

Power ( watt / channel ) at 8 ohms: 140 watt

Power ( watt / channel ) | Bridge ( 8 ohms ): 300 watt ( 4 channels )

Power  ( watt / channel ) at 70 Volts

Input Impedance: 20K ohms

Output Impedance ( Loop RCA ): 600 ohms

Input Sensitivity: 100 mV / 1 Watt, 1140 mV – Full power

Maximum Input Voltage: 2.9 Volt

Signal to Noise Ratio: -100 dB ( 20 Hz – 20k Hz )

Frequency Response: 5 Hz – 50k Hz

Total Harmonic Distortion THD + N @ 1K Hz: 0.03%

Rack Height: 1U

Dimensions including feet: ( H x W x D ): 2 ^1/16" x 17 ^1/4" x 16 ^13/16"

Width ( including rack brackets ): 19"

IP Communication: TCP / IP ( RJ-45 10 / 100 Base T )

Mains Operating Voltage: 
    100 – 120 Volts @ 60 Hz
    220 – 240 Volts @ 50 Hz

Fuse Rating: 10 A ( T10AL ~ 250 VAC )

Standby Power Consumption: <0.5 Watts ( green mode )

Networked Standby Power Consumption: <2 Watts

Weight: 16 lbs 6 oz