Facts about Mounting the IR emitter to equipment, Please Note! Peel the double stick adhesive tape off of the rear of the emitter to adhere to Audio-Video equipment once the IR receiver window on your equipment is properly located. If the location is confirmed to be working properly, always add a small bead of clear silicone around the outside of the emitter to insure it does not fall off over time due to temperature changes. Blinks-Flashes when IR signals are transmitted.

Optional

1. 92-160, IR 6 Port IR Repeater-Distribution System with Gain Control: 92-160
2. 92-180A, IR 6 Port IR Repeater-Distribution System: 92-180A

Specifications Individual Emitter:

- Termination Plug: 3.5mm Male ( Nickel Plated )

- Cable Length: 6 ft.

- Cable Gauge: 28 AWG x 2

- Frequency: Good for all 38Khz - 56Khz visible -infrared signal transmissions

- Emitter Size ( L x W x H ): 0.59" x 0.33" x 0.25"